Standard Installation covers:

Installation of the indoor unit in the roof cavity with standard round ceiling diffusers as below:

Up to 6KW – 3 diffusers
Up to 7KW – 4 diffusers
Up to 10KW – 5-7 diffusers
Up to 12KW – 7-9 diffusers
Up to 14KW – 9-11 diffusers
additional diffusers will be quoted separately

Installation of the outdoor unit on pavers that are placed on an appropriately levelled surface.
1x wall controller, 1x Hinge filter return air grille, Maximum pipe length 17m, Maximum trunking 4m
Penetrations through a timber wall or soffit.
Maximum 15m wiring & 4m of conduit to switchboard.
Further installation charges may occur for non-standard installation work. It can be quoted after pre-inspection.
Commercial installations and homes under construction are not included in the above prices.
For Pre-pipe and fit-off installations (newly built), supplementary cost will apply.

NOTE:

If installation does not fall under the above terms, then extra charges will be applied to cover labour and material cost.
Published prices are valid for regions within 60Km of our office address (Te Kauwhata)
For regions more than 60Km travel charges shall apply

What is Back-to-Back installation?

Back-to-Back installation means an indoor unit on the inside of the external wall and an outside unit within 3 metres of straight length on the outside. The Outdoor unit is to be placed on a poly slab with mounting feet.

As per the picture above back-to-back installation includes:

3 metres of copper pipes and communication cable between the units
PVC trunking to cover the copper piping and wires
Isolator switch (weatherproof)
1x PVC end cap
1x Poly slab (900mm X 450mm)
Electrical power socket on the same wall (within 3 metres) for small capacity units
Electrical cable 10 metres from outdoor unit to switchboard either through under house space or ceiling cavity for large capacity units

NOTE: If installation does not fall under the above terms, extra charges will be applied to cover labour and material costs.

Trending now